TASSCO GOLDEN ARM
CRACK FREE HARD SURFACE

• Gas shielded (75 Argon/25 CO₂), flux cored, ALL-POSITION, general purpose, hardfacing wire.
• Offers good balance of impact and abrasion resistance.
• Can be used in both metal-to-metal and metal-to-earth applications.
• maintain smooth, semi spray transfer and can be applied to carbon, low alloy and manganese steels, without cracking.
• 57-62 HRC (2 layers)

TASSCO GOLDEN ARM
CHROME FREE HARD SURFACE

• Non-chromium heart facing welding wire which result in a deposit that has wire resistance and hardness equal to or greater than conventional carbide deposits.
• Specifically formulated to eliminate chromium in the wire and still provide outstanding wear resistance.
• Provide wear-resistant overlay for applications were hexavalent chromium, and welding fumes cannot be reduced work practice controls.
• The emission of hexavalent chromium during welding is reduced - or completely eliminated - depending on the chromium content of the base or pre-existing weld deposit.
• 67-71 HRC (2 layers max)

TASSCO GOLDEN ARM
CORRHARD WIRE

• May be welded within a wide range of parameters.
• Commonly used for welding stainless steel to mild steel.
• Exhibits a "spray-like" arc transfer.

TASSCO GOLDEN ARM
XT/HD WIRE

• Produces diffusible Hydrogen levels of <4mL/100g over a wide range of welding parameters.
• Wide range of applications include abrasion resistant steels, heavy machinery, rail car, petrochemical equipment, bridge fabrication, and ship fabrication.
• Commonly used for welding various high strength steels.
• Produces strong, tough welds with good impact resistance at low temperatures.
• Tensile (>80 ksi)
• Yield (>68 ksi)
• Elongation (>19%)

TASSCO GOLDEN ARM
COMP-C

• Deposits an alloy with a high density of primary chromium carbides in an iron matrix.
• Abrasion resistance is high, with moderate impact resistance.
• Deposits develop a tight cross-checking pattern for stress relief.
• Designed for metal-to-eary wear resistance: grinding/pulverizing rolls and table segments, wear plates, clad pipe, dredge pump shells and related components, and hammers.
• Most economical choice for high-wear applications.
• May be utilized in hot wear applications up to 900º F.
• May NOT be machined or forged.
• 56-64 HRC (2 layers max)

‍

‍